Grill Hose
Guided verification

Type 1 / QCC1 to 3/8 in female SAE flare regulator hose

A common low-pressure LP grill category. The familiar tank nut does not prove outlet pressure, appliance-end size, flow, or model fit.

This page coversType 1 / QCC1 cylinder connection, fixed low-pressure regulator, and 3/8 in female SAE flare appliance end
Connector pictures

Compare the photographs and illustrations

A picture can help identify the connector family. It cannot measure a thread, establish pressure, or prove that a part belongs on your appliance. Manufacturer references are linked below each example.

A black Type 1 QCC1 handwheel connecting a grill regulator to a propane cylinderActual photograph
The common Type 1 / QCC1 tank connection on a standard propane grill. The black handwheel tightens over the cylinder valve's outside ACME threads.Photo by Ciaran Roche · Used with permission
Common modern 20 lb propane-cylinder connection

Type 1 / QCC1

Large hand-tightening nut that threads over the outside of the tank valve.

A familiar tank end does not establish the required regulator pressure or appliance-end fitting.
Traceable manufacturer referencesManufacturer photograph of a QCC1 grill regulator assemblyMr. Heater F271161, Type 1 / QCC1 to 3/8 in female flare
Technical illustration of a 3/8 inch female SAE 45-degree flare swivel hose fitting with its internal seat visibleTechnical illustration
A verified 3/8 in SAE 45-degree female flare hose-end example. The nut's straight internal threads draw the fitting together, while the recessed metal seat makes the seal. This is not a dimensional drawing.Original Grill Hose technical illustration · Geometry reference: MB Sturgis SKU 204003
Common appliance end on low-pressure LP regulator assemblies

3/8 in female flare

Swivel hex nut with an internal flare seat; it seals at the flare, not on pipe threads.

The metal flare seat makes the seal. Confirm the exact size, mating male flare, and documented assembly method.
Traceable manufacturer referencesManufacturer reference for the illustrated 3/8 in female flare hose endMB Sturgis 204003, 3/8 in 45-degree female flare seat x 3/8 in barbManufacturer photograph of the complete female-flare hose endMr. Heater F271161, QCC1 regulator with 3/8 in female SAE flareManufacturer photograph of female flare swivel nutsBrassCraft 114FSV-6, 3/8 in OD tube swivel flare union

Confirm every one of these

  • The appliance manual states low-pressure LP and gives the required regulator outlet pressure.
  • The appliance inlet is exactly 3/8 in male SAE flare, not NPT and not another nominal size.
  • The hose length, capacity, routing, heat clearance, and safety listing meet the current appliance instructions.
Five checks before choosing

Confirm the complete specification first.

The guide asks about the fuel, appliance use, both hose ends, required length, and manufacturer documentation. It does not show a manufacturer reference until all five checks are complete.

Start the five checksSee a manufacturer example of this connector pairing
Products with published specifications

Manufacturer-specified products

These are manufacturer products for stated models or uses. They are not universal hoses. Check the source and your exact appliance before choosing one.

Compatibility not verified.

We do not have a single verified product for this category. Product pages often leave out pressure, mating profile, capacity, certification, or model coverage. Use the guided comparison only after confirming those details in current documentation.

Sources

Sources reviewed

Mr. Heater manufacturer example of the connector pairing Parker SAE 45-degree flare assembly guide
Browse all fitting guidesStart with my grill model